The installation methods and precautions of anchor cables vary depending on the type and purpose of the anchor cable. In general, the installation of anchor cables is divided into the following steps:

1. Drilling: First of all, you need to drill holes on the slope, and the depth and diameter of the drilling need to be determined according to the length and diameter of the anchor cable. When drilling, care needs to be taken to maintain the verticality of the drilled hole, and whether the depth and diameter of the drilled hole meet the requirements.

2. Cleaning: Cleaning is to ensure the cleanliness of the inside of the anchor hole to facilitate the installation of the anchor cable. When cleaning, you need to use a high-pressure fan or water gun to remove the debris inside the anchor hole.

3. Installation: When installing, you need to feed the anchor cable into the anchor hole, and then tension. The following points need to be noted during installation:

Whether the anchor cable number is consistent with the hole number.

After confirmation, clean again with high-pressure air.

Check the position of the positioning stop ring and the limit ring, and replace the damaged according to the technical requirements.

Check the position and unobstruction of the exhaust pipe.

The anchor cable is fed into the hole, and when the anchor cable reaches the predetermined position, it is tensioned.

4. Consolidation: Consolidation is to ensure the tight combination between the anchor cable and the slope. When consolidating, it is necessary to use a grouting machine to inject the grouting material into the inside of the anchor hole.

During the installation process, you need to pay attention to safety issues, such as wearing safety helmets, safety ropes, etc. At the same time, it is necessary to select the appropriate anchor type and specification according to the specific situation